Mitel 5604 Guide de l'utilisateur télécharger pdf (Page 41)

5604 Wireless Handset User Guide

Colored Messaging

It is possible to send colored messages to handsets. The sender of a message (that is, an

application) determines the color of the message. Colored messaging can be useful for

categorizing messages. In figure 8, there are two colored messages (a new message, and a

read message) in the message inbox (left in the figure). The messages are indicated by a

gradient color bar behind the envelopes. When reading a message, a gradient color bar is

shown below the envelop (right in the figure).

Figure 8: Shows an example of a colored message

To enable colored messaging, see the corresponding manual for the application used. In

addition, colored labels can be mapped to message beep codes. See IP-DECT WSM

Installation and Operation Manual.

Mobile Data

Send Mobile Data

It is possible to send user entered data from the handset by pressing a pre-programmed Hot

key or Soft key, or selecting a Service. Mobile data can be used for opening a door,

starting/stopping a machine etc. The data can either be predefined, or entered after the Hot

key/Soft key is pressed or Service is selected.

The data can be predefined when programming the Soft/Hot key or Service, see Define Soft

Keys on page 54, Define Hot Keys on page 54, or Add Services on page 56.

Send Mobile Data with a Prefix

Mobile data with a prefix is sent from the handset by entering data and then pressing a

pre-programmed Hot key or Soft key or select a Service. Mobile data with prefix can be used

to send information to an application in the system.

Note: This is a system dependent feature for 5604 Services license only.

12:34

Call

Reject

2009-01-01 12:00

Patient ready for transport.

From: X-ray

To: B/12/3

Help

12:34

View

Back

Patient ready...

2009-01-01

Patient ready...

2009-01-01

Inbox

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 89 90

Pas de commentaire

Mitel 5604 Guide de l'utilisateur Page 41